Niblet, a Chihuahua puppy in the care of Chattanooga’s Humane Educational Society, is a little dog with a big problem.
The adorable, 2.5-pound pup has a dime-sized hole in his skull. It’s on top of his head, midway between his ears, and any hard blow to the spot could cause brain damage, according to a society vet.
As long as Nilblet doesn’t get hit on the soft spot, he’s fine. But that’s a big “ask” for an active puppy. The birth defect, caused by a condition called hydrocephalus (water on the brain), is not expected to fuse naturally, so this is likely a lifetime problem for Niblet. Even a swat from a cat’s claw could cause grave injury.
In a combination of applied technology and big-hearted volunteerism, Niblet has been gifted with a solution.
The University of Tennessee at Chattanooga mechanical engineering department has made two pieces of custom headgear for the little dog: a 3D-printed helmet made of soft plastic and a bonnet made of carbon fiber. (A commercially purchased helmet for Niblet would have cost $700, which was too expensive for the Humane Educational Society to even consider.)
