Skip to main content
Monday, November 16, 2026Nov 16

US investigating if Boeing made sure a part that blew off a jet was made to design standards

This image taken Sunday, Jan. 7, 2024, and released by the National Transportation Safety Board, shows a section of Alaska Airlines Flight 1282 that is missing panel on a Boeing 737-9 MAX in Portland, Ore. Federal officials are investigating Boeing's oversight of production of a panel that blew off a jetliner in midflight last week.  (NTSB via AP)
This image taken Sunday, Jan. 7, 2024, and released by the National Transportation Safety Board, shows a section of Alaska Airlines Flight 1282 that is missing panel on a Boeing 737-9 MAX in Portland, Ore. Federal officials are investigating Boeing's oversight of production of a panel that blew off a jetliner in midflight last week. (NTSB via AP)

The Federal Aviation Administration is investigating whether Boeing failed to make sure a panel that blew off a jetliner in midflight last week was safe and manufactured to meet the design that regulators approved.

Boeing said Thursday it would cooperate with the investigation, which is focusing on plugs used to fill spots for extra doors when those exits are not required for safety reasons on Boeing 737 Max 9 jetliners.

One of two plugs on an Alaska Airlines jetliner blew out shortly after the plane took off from Portland, Oregon, leaving a hole in the plane.

“This incident should have never happened,and it cannot happen again,” the FAA said. “Boeing’s manufacturing practices need to comply with the high safety standards they’re legally accountable to meet.”

The FAA notified Boeing of the investigation in a letter dated Wednesday.